Forum > LCD TV forum

Vestel 17MB62 - 1 Sound issues.

<< < (2/2)

bonesy:
I've got some very good tweezers,I put a small amount of solder on one solder pad,hold the tiny cap towards opposite end,heat solder,slide into place,then solder other end.It does take me ages,hands not as steady as they use to be.

cheeky2:
I know its an old post but just adding my advice after completing my first repair of these boards.
 I used a paste flux on the main board to hold in place the smd capacitor then with a pin held it at the middle whilst applied heat to one end. The flux gave it something to stick to instead of the needle tipped soldering iron. This was carried out under a microscope to align it and whilst soldering the components in place. I was pleasantly surprised how well it went after expecting the caps to disappear. I doubt I would have been able to achieve the results without the microscope as my eyesight is good but not that good for these very small components.

Davy:
Is this the same board????

See this  video  https://www.youtube.com/watch?v=JV-v9CfH7ow

Check if headphone work and check speaker muting voltage - uses separate headphone amp. In my case the audio chip NTP8230 faulty, check voltages to chip.


Edit:
17MB65 Service manual  https://elektrotanya.com/vestel_17mb65.pdf/download.html


Dave

Navigation

[0] Message Index

[*] Previous page