Forum > LCD TV forum

Screen VES315WNDL-01

<< < (2/2)

vinceroger69:
Yes thats the ones i have ordered thanks again.

Turnip:
Hi folks,

Think mention after replacing the two duff Leds - All OK.

Seems then that the 17IPS19-5 can suss two duff Leds cutting supply to a basic 25v feed.

Checked supply voltages from the menu - Max 85v  Mid 78v  Min 75v -  Set it to Mid so it doesn't come back for a while - Chris.

Just sorted another one, one burned and S/C Led. As it's such a pain to lift the strips, thought try Bonesys idea - Crumble the top, clean the area, remove surface covering so there's enough exposed copper. Use LMP solder and an iron bit wide enough to melt both sides at the same time and watch the new Led sink into place - Much faster with this screen, but doesn't work so easily with the ones where both sides of the Led are at the same potential for heat sinking, and the feed to the next Led is in fine print.

cheeky2:
I tend to use a wallpaper scraper to lift the strips off of the metal frame, it requires a fair amount of force to get them up initially but prevents the lenses from popping off :)
 Also noticed one seller selling those leds 300 for £11+ postage better price than buying a thousand of them! I suspect the price should be £21 so I ordered some! I will keep a few and sell the rest on ebay!
http://www.ebay.co.uk/itm/252450138118

Turnip:
Hi Cheeky,

Them leds is getting cheaper all the time. Suspect time you get your spares on Ebay they'll be even cheaper.

Currently paying 10p a pop, and as usually need just two or three - Margin is pretty good, but have to allow for folks who turn the backlight up to 100% within 3 months and pop a few more.

Currently a good earner with 32 inch stuff - Chris.

Navigation

[0] Message Index

[*] Previous page