Forum > LCD TV forum

Alba LCD W16hdf blue light flashing

<< < (2/2)

vinceroger69:
Locate the eeprom/flash ic ic and freeze it with freeze spray does the tv now start ok?
some people say heat these ics but i have had no luck doing that.

Turnip:
Hi harvey,

Just realised the power board uses an inverter transformer to drive the screen tubes. Tranny goes S/C turns so set won't start. Gather original small transformer is unavailable, but the later one with dual outputs might still be.
If it's the dual output one, check the secondary resistances with an accurate meter, where any difference between them indicates a duff tranny - Chris.

harvey:
Thanks Turnip for the suggestion. I will have a go at the Tranny if I could find the shorted turns. Regards

Navigation

[0] Message Index

[*] Previous page