Forum > LCD TV forum
panasonic tx-l32x3b
t1412:
I tried what it said, now the standby light is flashing red thanks
Turnip:
Hi t1412
Exactly the same myself, so suspect a duff SSB, but will go on pressing buttons for a while. Suspect when makers use a big heat sink over the M'Proc, there's liable to be issues, but at least with LG, heat sort's most issues for a while.
Read something today where knowing folks supect it's whiskers which used to give issues with early Mullard transistors.
Not convinced, but curious as LG sets are mostly sorted by 200C in the oven for ten minutes, even if you need do it twice.
Sadly it doesn't work with anything else - Tried quite a few times - Chris.
Turnip:
Eventually tried pressing buttons in any sequence, where after a while the Green Led started to flash, so did as suggested, all now seems OK - Chris.
Had a 37 inch version in today for the same issue - Seems an earner.
t1412:
hi manage to get the set back on, set the firmware to off retune the tv seemed to work great i've sold it on but the customer saying not switching on after couple of weeks has anyone had this fault bounce back on them or have i missed something thanks
shaun
Davy:
The Panny TX-L32X5B that was playing funnies, as in my earlier post still working.... sounds like it suffered the same fault according to the symptoms, dunno if it's the same board.
Dave
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version