Forum > LCD TV forum

Panasonic TX50AX802B

(1/2) > >>

Turnip:
Hi folks,

Have one giving just the Panasonic logo then set cuts to S/by with 13 s/by Led flashes.

Any ideas ? - Thanks - Chris.

downunder:

Hi Chris,

Code 13 is an emergency SOS usually attributable to the A-Board, but I'd be pulling out the LED tester and checking the backlights, although they usually give you code 1. Rather you than me.                         Bruce

Turnip:
Thanks Bruce,

LCD set for some reason is as heavy as a plasma, suspect the stand does lower frequencies.

Bit daft for a Panasonic but who is one to cast anything ? Chris

PS - Backlights seem nifty, if it was an LG would cook it.

Turnip:
Hi Bruce,

Guess the 'A-Board' is the SSB. Thought try update firmware via USB but the set wouldn't have any of it, just sat there saying 'Panasonic' 'till it cut to S/by after five minutes.

Recall a Quuq chap a while ago had the same set, where occasionally it gave a picture of sorts so he could update it to perfection - 'Bonesy' as I remember, but sadly he seems to have vanished from Quuq, though thought him nifty - Chris.

downunder:

Hi Chris,

Yes, A-board = SSB board = main board. Code 1 is a failure of communication between the panel micro and the system micro.
These are both located on the A-board, so draw your own conclusion.

Too bad that Panasonic main boards are unresponsive to cooking. Off to fleabay I guess.                                 Bruce

Navigation

[0] Message Index

[#] Next page