Forum > LCD TV forum
Sony kdl49we 5 blinks
downunder:
It certainly looks a bit suspect. Heat damage or physical damage? Be an idea to remove it at both ends and check each wire for continuity and shorts to adjacent wires. Just a thought.
vikivng:
Ok..trying to remove the other end seems a bit tricky.
How does this connector work to release .?
vikivng:
Are these cables normally compatitible to other similarly sized and branded tvs?
I have seen a cable for kdl49we663 model.Mine being the ..753 model.
downunder:
Re the connector: the small black bits at each end will depress, and release a notch in each side of the flexi. So depress one side and pull that end of the flexi outwards slightly, then do the other side and repeat till it's free. Don't like these as a few fittings and removals seems to damage the print that goes into the socket. Same with refitting except in reverse. I recently had to trim off the notches at each side of the flexi
to facilitate easier refitting.
Compatibility is a matter of luck - different widths, number of traces, attaching systems, etc. Bruce
vikivng:
Wow Bruce,
lol,,try as I might in all directions, this cable seems very hard to move.
Im obviously trying to be very gentle..Maybe too gentle until I know the direction is correct.
It doesnt seem to depress..What is the cable called ? so I can try to find a video.
I have seen the LVDS connectors on samsung seem to squeeze in towards each other but this doesnt do that it seems.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version