Forum > PLASMA TV forum

pioneer pdp436pe

(1/2) > >>

terminator2k2:
hi there, i have the above model for repair , fault is

switch set on , reverts back to standby with the red led flashing 7 times (which after looking on the net means a y sustain board fault)

im a bit hesitant to replace this board as i find no s/c ot burnt components.and this board is expensive to keep as a spare incase it isnt this..... :oops:

the voltages coming from the power supply seem ok. just wandering if anyone has any experience with this model of set or any ideas what to look for.....

cheers chris

tai_th2002:
Hi,

I'm have repair few set this model before but the model we repair is pdp-436pg( asia model )
The problem you mention we have repair before & we just is replacement the board only.
The part number we using is AWV2256, don't know the part number for other country is simular or not.
Inside service manual is mention just repalcement with part only, no replacement part is supply.
How much the cost is selling in you country? Can you tell me....
Thank you

 :ciao:

terminator2k2:
hi there, the same pcb " Pcb Y Drive (AWV2256) " is roughly £200 + vat from our supplier...making the reapir roughly £350 - £400

tai_th2002:
Hi,

Thank you for you reply. Thepart price in you country sell very expensive compare with our country.
The part price we get form agent just is around malaysian ringgit MYR 700 only ~  around £100 only.
Have you ready solve the problem? You are plan to repairing the pcb or replacement the pcb?

Thank you

terminator2k2:
customer didnt want to go ahead with the repair and collected the set......

so i suppose ill never know if the y sus board was the cause of the problem...

thanks for your help , much appreciated...

Navigation

[0] Message Index

[#] Next page