Forum > PLASMA TV forum
LG with black line down middle
BC109:
More than likely it's COF (Chip On Film) connector at bottom of panel. Resolder the 4x SMD resistors on the film. The faulty connector will be inline with your 20mm line.
Generally a good idea to do all film connectors.
nskeates:
well the new plasma came yesterday from the insurance company and the old one was not taken so i now want to fix the old one. :biggrin2:
has anybody got a picture/diagram of what i need to solder ? never had a back of a plasma off before !!
thanks
neil
backpage:
hello...it does sound like a bad connection...this will be from the control board to the screen...all the plasic film strips will need cleaning,(with metho)..be careful you doent bend pins...can be a bitch to refit the tapes back in their slots..dont dispare though .once you get the hang off fitting them in,you will do fine ...also check all solder joints on the base connectors were these go in...
Ohm Supplies:
I'm sure someone should of mentioned this but do you have a decent solder iorn.
I take it your not a tv engineer, are you really sure that you want to be taking the back off? its a pain to get down to cof's and I think your modle is a V6 so its more likley to be panel (so you done have anything to loose I suppose) but you would need a fairly small point to do the job properly.
regards
Andy
Navigation
[0] Message Index
[*] Previous page
Go to full version