Forum > LCD TV forum

Wharfedale LCD3210HDAF

<< < (2/2)

Ohm Supplies:
Norman,


I've just added all the cct. refs to the kits we sell on our webby, its not a bad idea to check them if you have a power supply problem as although the kits are to fix a dead supply they do sort quite a few problems with the board cutting off, after your swapped the 2 caps tony has said.

To pull the supply out of stand by you only need a couple of volts so you need a seperate power supply, I'll get the notes we use in work but you need to check if the votages are there in full, lower than they should be or varying.

untill they're steady then you dont need to be worrying about adding any extra voltages as its likley to blow something (else)

regards
Andy

norman:
Hi guys, Thanks for the replies. The caps C877/878 are fine. The fet Q837 checks ok? I have two of these boards and the readings are the same on them. I can't try these in the set as they are an earlier version which doesn't fit (different connectors). The standby supplies seem ok. The circuit I have is very poor quality and not easily read. Does anyone have any training course notes for these? Hitachi used to be good for notes but I don't get to any courses assuming they still run them. I will have a look at your site (ohm supplies) for further information. Any further suggestions most welcome. Cheers Norman.

norman:
I had another go at this today and found one of the double diode packages short circuit. (new I had missed something simple). I would still be interested to see you notes on this supply Tony if you can oblige. Many thanks for your input guys. Norman

Navigation

[0] Message Index

[*] Previous page