Forum > LCD TV forum
Samsung LE40R87BD LCD TV - relay clicking repeatedly but wont start
Contrast John:
Footnote
Noticed when switching between analogue and digital tv, the video signal didnt mute ( unsightly hash on screen). Had to go back into option 8 and set the video mute time. Found 5 seconds about right (it had reverted to 0 secs). All ok now.
John.
sparky:
Hi
Have got same fault replaced caps in psu bulging still clicking did reset as you wrote
came out of standby tried opion 8 still no anolgue or digital, works via scart skt
when going on to standby starts clicking again have to reset chipto get tv out of standby
Do you think eeprom chip faulty
Sparky
Contrast John:
Hi Sparky
Seems that the problem is related to the eeprom IC. Might be worth checking all other options and settings with the correct service manual. When I repaired mine I noticed some other values in option 8 appeared corrupted and were not as suggested in the manual I have (LE32M86), although it gave me just enough information to get the set going again. Think you may need to check everything though and not just option 8. I noted there are some Hotel Mode settings in the manual I have and also power up settings. If everything checks out the Eeprom is probably faulty. Hope this info is of some help.
Good Luck
John.
sparky:
Morning John:
Thanks for getting back will try and get service manual
and check the setting of eeprom ic etc
Sparky
adm2007:
changed caps in power supply was still clicking reset eprom and follwed advice above .set comes on but no tuning ,got manual but seems different to model. model no le40r88bdx/xeu any one got option info for this model (bord plus) thanks carl
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version