Forum > LCD TV forum

PHILIPS 47PFL5522D LC7.2E

(1/2) > >>

daz:
hello all
this ones got an odd fault,it is stuck in digi mode with no tv picture,no menu or channel  change buttons work, but the volume graphic apears on the screen when vol + or - pressed. carnt enter smode or change to analogue.
any ideas

sparky:
hi
had sim  fault on 22" lg only tv control  worked no sound or col tried thro
scart got no sound or col, fault turned out eprom corrupted had to
change motherboard

In_Focus:
Give this a try.

Switch on and hold down both Vol+ and Vol- buttons on the side of the TV for about 10-15 seconds. The set should reboot and the install menu should appear. I see this most often on sets which are being used with poor digital reception.

daz:
thanks for the reply
managed to get set into smode by shorting the sam pads on the main signal pcb and reseting the software,this got the analogue working and the video inputs,but not the digi, as customer uses sky they where happy,but suspect the software is corrupt but you need compair to reprogramme it.
good old philips

taloola:
hi, i have just had this fault on the same model set as yours. it seems to be a corrupt NVM.if you download the service manual it tells you how to reload NVM to its default values .take the back off the set and find the sdm points on main board.with everything turned off short sdm points on the main board press the +channel button on the tv not the remote, then turn on from the mains. when you release the channel button it should flash a couple of times then say uploaded.turn off then on again and set should be ok.this method might take a couple of goes

Navigation

[0] Message Index

[#] Next page