Forum > LCD TV forum

maxim 37" lcd tv psu ic chip blown

<< < (3/3)

Ohm Supplies:
I think Sparky is a nearer with the board type, although its a slightly different board. Poflio who make it have a tendancy to use the same basic type in many sets, Versions A, B,C,D,E etc. all doing the same job but not interchangable

The very odd thing is if the FSD200 has blown up, then how is the set switching on without a 5v stand by rail? None of the other voltages will be there

regards
Andy

joeontherun:
Good question about the fsd200 i to be honest do not have a clue i thought it was that that was causing it to be faulty so i dont have a clue as to why it would randomly switch on with only the back light and some times show strips on the screen,

From what your saying if the fsd200 blows it should not switch on at all which is not the case here ok the screen or buttons do not function and some times it dosent switch on but if a switch it a few times i get a light that stays on and then switch it again it wont come on, I would like to send it out to get repaired as its got me clueless,

Navigation

[0] Message Index

[*] Previous page