Forum > LCD TV forum

sharp lc26p50e

(1/2) > >>

sparky:
hi
i have the above tv when switched light goes green then almost yellow
then two flashing standby lights and clicking not come across this
chassis before, have disconnected inverter still same help if poss
there is info in euras but not registered
sparky

Contrast John:
Hi sparky
Just repaired a couple of Sharp lcd tvs with similar problems. The problem was data corruption. Managed to start them up in the service mode and carry out `eep clear` in the service menu.
Entered the service mode by simultaneously pressing `input` and `vol-`on the tv whilst applying the mains. It took a few attempts before the screen lit and displayed the letter K. Then press`vol-`and `prog-`on the tv and the service menu should appear. Its also worth checking the lamp error counter in the menus as 5 errors can cause some models to lock up. Not the same models as yours but reckon its worth a try.
Regards
John.

sparky:
hi
thanks for info done as above all ok
thanks
sparky

tv john:
Hi Sparkie,I WAS SCRIBBLING DOWN LOTS OF NOTES from that site,but contrast john had the answer. I highly recomend subscribing to that site because in one week in Dec 09 I got  tips that fixed 2 lcd's. They don't have all the answers,but worth every penny at £19/month.
On the Sharp model above there was too much info to list for similar problems to yours.

John.

sparky:
hi
thanks for looking will have to think about euras
sparky

Navigation

[0] Message Index

[#] Next page