Forum > LCD TV forum

Bush IDLCD32TV05HD beko psu Z1J.194-04 dead no standby

(1/2) > >>

Tmg:
Hello
I have this bush for repair it is dead, found 4x 1000uf caps bulging on the 12v line (replaced)
I have also tested for the following with no luck
R954, D909, IC901, all ok
To test psu add 6v2 zener from pin 2>1
there are 2 outputs on this psu 24v comes up and after a while dies away
and 12v (pin 2) only comes up to 1.3v
This psu has sprung into life once and ran with good output voltages.
I have swapped components over from the 12v psu to the 24v psu which are the same with still no luck.
Can anyone help,
or does anyone have a manual for this
Regards
Tony.

Turnip:
Hi TMG,

What is it - well, few numbers or piccies - our Sparky might get distressed (he's an info man - others do it with table tapping) - Chris

Contrast John:
Hi Tmg
Have attached file of psu
Regards
John.

EARLYBIRD:
Hi.Solder all the sockets they are terrible for dry joints should cure problem.These connections can cause allsorts of intermittent problems.

Tmg:
Thank you John for the psu circuit now I can crack on and check all the rest of the components that I was unable to swap of to the 24v psu side.
I have also resoldered the whole pcb with no luck.
Chris Much table tapping was done on this thing certainly wont forget this one= (The 3 years out of the trade means I have a lot of catching up to do these days)
Regards
Tony.

Navigation

[0] Message Index

[#] Next page