Author Topic: SHARP LC32DH66E (Read 6077 times)

digitech1962 · « **on:** February 14, 2011,04:56:12 »

This sharp has dead fault led green but wont start up TV has come on very int thanks .Digi Dave.

Mulja tv repair portal · « **on:** February 14, 2011,04:56:12 »

Synyrgy · « **Reply #1 on:** February 17, 2011,11:42:29 »

When you say dead fault; do you mean no power indicator light or any signs of power to unit?
Have you checked the power cord, Voltage to unit, Fuse, Bridge rectifier? First things first, Make sure you have 120 VAC to the unit then go from there. Keep me posted? Triumphantcc@yahoo.com

sparky · « **Reply #2 on:** February 17, 2011,12:00:54 »

hi
the supply voltage in uk 240 in usa 120v
check the earthing screws on the inverter
they can cause a few strange faults
dave

Mulja tv repair portal · « **Reply #2 on:** February 17, 2011,12:00:54 »

sparkman001 · « **Reply #3 on:** February 17, 2011,19:13:03 »

Hi, try this, press 'input' and 'volume -' on the TV button panel and hold down, then power the set on. If it powers on you should see a 'K' on the screen, press vol- and prog + and you will enter the service mode. scroll through it and reset the backlight error to 0, then power down and restart. Hopefully it will come on as normal. It may be that you have a faulty backlight tube, so try that first.

Kilroys · « **Reply #4 on:** February 19, 2011,05:41:19 »

Could you sometime get the tv working ?
Take looong time before the picture come ?
Take a look at this

digitech1962 · « **Reply #5 on:** February 21, 2011,15:46:26 »

Yes it does sometimes start up but when unplug tv goes back to just green or amber led .

Mulja tv repair portal · « **Reply #5 on:** February 21, 2011,15:46:26 »

digitech1962 · « **Reply #6 on:** February 23, 2011,15:58:59 »

Thanks for info this points to main board fault thanks.

Mulja tv repair portal · « **Reply #6 on:** February 23, 2011,15:58:59 »

Mulja tv repair portal

News: