Forum > LCD TV forum

BEKO Z1J194-11 PSU NO 24V OUTPUT

(1/2) > >>

A.G LCD TV REPAIRS:
Hi all new to the site and need advice on beko z1j194-11 psu

The problem i have is the tv is on standby and led is on when switched on the led dimms then goes bright again and thats it ?
Taken board out and replaced caps with no joy ,the 12v side is only reading 10.3v and 24v side only reads 3.3v has anyone come across this before with these boards ?

thankyou in advance

epi:
Hi A.G
Check this thread there's a schematic there too.

http://www.tv.quuq.org/forum/index.php?topic=3392

A.G LCD TV REPAIRS:

--- Quote from: epi on February 24, 2011,02:59:59 ---Hi A.G
Check this thread there's a schematic there too.

http://www.tv.quuq.org/forum/index.php?topic=3392


--- End quote ---

thankyou ill take a look

A.G LCD TV REPAIRS:
no luck with that thread still no 24v output im lost on this one

Turnip:
Hi AG,

Just a thought - the circuit looks awfully Profilo Telra in some areas where drooly caps and S/C zeners are always a prob - why not check around that 24v supply, as you have a similar one to compare.

All the best - Chris

Navigation

[0] Message Index

[#] Next page