Author Topic: BEKO Z1J194-11 PSU NO 24V OUTPUT (Read 14051 times)

A.G LCD TV REPAIRS · « **on:** February 23, 2011,20:24:23 »

Hi all new to the site and need advice on beko z1j194-11 psu

The problem i have is the tv is on standby and led is on when switched on the led dimms then goes bright again and thats it ?
Taken board out and replaced caps with no joy ,the 12v side is only reading 10.3v and 24v side only reads 3.3v has anyone come across this before with these boards ?

thankyou in advance

Mulja tv repair portal · « **on:** February 23, 2011,20:24:23 »

epi · « **Reply #1 on:** February 24, 2011,02:59:59 »

Hi A.G
Check this thread there's a schematic there too.

http://www.tv.quuq.org/forum/index.php?topic=3392

A.G LCD TV REPAIRS · « **Reply #2 on:** February 24, 2011,09:53:50 »

Quote from: epi on February 24, 2011,02:59:59

Hi A.G
Check this thread there's a schematic there too.

http://www.tv.quuq.org/forum/index.php?topic=3392

thankyou ill take a look

Mulja tv repair portal · « **Reply #2 on:** February 24, 2011,09:53:50 »

A.G LCD TV REPAIRS · « **Reply #3 on:** February 24, 2011,11:56:38 »

no luck with that thread still no 24v output im lost on this one

Turnip · « **Reply #4 on:** February 24, 2011,12:18:16 »

Hi AG,

Just a thought - the circuit looks awfully Profilo Telra in some areas where drooly caps and S/C zeners are always a prob - why not check around that 24v supply, as you have a similar one to compare.

All the best - Chris

Tmg · « **Reply #5 on:** February 24, 2011,14:47:09 »

Hi I remember one of my posts where I had a bush that used the same power suppy, I spent days on the think replacing, checkin, swaping parts between 12 and 24v supply on the board all with no luck.
In the end I found someone selling a second hand working board that fixed it.

Equipment Repairs / LCD TV forum / Bush IDLCD32TV05HD beko psu Z1J.194-04 dead no standby on: 08 September 2010, 23:02:56
Hello
I have this bush for repair it is dead, found 4x 1000uf caps bulging on the 12v line (replaced)
I have also tested for the following with no luck
R954, D909, IC901, all ok
To test psu add 6v2 zener from pin 2>1
there are 2 outputs on this psu 24v comes up and after a while dies away
and 12v (pin 2) only comes up to 1.3v
This psu has sprung into life once and ran with good output voltages.
I have swapped components over from the 12v psu to the 24v psu which are the same with still no luck.

Mulja tv repair portal · « **Reply #5 on:** February 24, 2011,14:47:09 »

A.G LCD TV REPAIRS · « **Reply #6 on:** February 24, 2011,15:31:36 »

Hi ive now got 12v and 24v power with standby light on but every time i press standby nothing just the led dims then bright again any ideas
thanks for reply
Andy

Mulja tv repair portal · « **Reply #6 on:** February 24, 2011,15:31:36 »

Mulja tv repair portal

News: