Forum > CRT TV forum

BEKO NR35228PD

(1/2) > >>

t1412:
ok guys got this old beko it's a nr35228pd repairiing it for an old lady up the road. at switch on dead took the back off found main fuse blown put another1 same again tested output transistor ok . any other ideas got a feeling it could be the lopty cheers

shaun :sign0085:   

daz:
hi
check psu for shorts, if none change positor
good luck
daz

t1412:
cheers daz you would happen to have a schematic knocking about cheers

shaun :c017:   

daz:
sorry shaun dont have one for this set, but some other quuqer might

Turnip:
Hi T1412,

Had lots of tubed Beko in where spurious mains fuse blowing was a decent earner - got rid of most my positors apart from those odd Philips ones that were not series in operation - typical Philips - they just have to do it differently.

Have a schematic - attached - all the best - Chris

Navigation

[0] Message Index

[#] Next page