Forum > LCD TV forum

Samsung LS22TDVSUV No go

<< < (3/3)

jimca007:
Try this mate came from the service manual, TIP: How to drive the circuit by force when LCD panel Lamp is faulty.
- It is available to drive the circuit when the pin of 2 in Main_Power_control CN1101
connect the pin of 4.
In other words solder together pins 2 and 4 of the connector CN1101 the one between the PSU and Main I think from memory, and it disables the lamp out failure circuit

Turnip:
Hi Jimca, and thanks,

Will try your suggestion and check back - Chris.

Turnip:
Hi folks,

Eventually checked inverter Tx found it 700 Ohms one secondary and 5K the other - replacement did the biz. If anyone needs a tranny, bought 10 of them (TM-0917 NYD741FC)

Again, many thanks - Chris.

Navigation

[0] Message Index

[*] Previous page