Author Topic: Toshiba 19W330DB no DTV/HDMI but Analogue TV & SCART OK?  (Read 5859 times)

0 Members and 1 Guest are viewing this topic.

Woorlord

  • Newbie
  • *
  • Posts: 2
    • Email
Have a Toshiba 19W330DB which will not display a picture/sound when set to DTV (Freeview) input.

Also checked the HDMI input where I have Sky box input and also no picture/sound.  OSD acknowledges 720p signal and also found sound cycles on/off every 10-20 seconds?

Checked the Analogue TV Tuner, which have never used and found I can get a tuned picture and sound on various terrestrial channels - although sound cycles on/off every 10-20 seconds?

Checked the SCART input with an ipod video feed - picture good, and again similar issue with sound drop out as other inputs.

Have got into the service menu on the TV input (Menu4725) and done a NV Reset - no change in operation.

Opened up the panel and found the unit has a "Vestel 17MB24H 2" main board.

Any idea's why the DTV/HDMI inputs are not working??
I assume this may be related to the sound drop out?
Is there any way to reflash the firmware - as read on other Toshiba related threads, try a firmware flash before replacing the main digital board.

Any helps/tips appreciated.
Many Thanks in advance.

Mulja tv repair portal


astracat

  • Hero Member
  • *****
  • Posts: 325
    • Email
Re: Toshiba 19W330DB no DTV/HDMI but Analogue TV & SCART OK?
« Reply #1 on: June 01, 2011,15:48:41 »
hiya
have you checked in service mode that correct settings are set for digital board ,had simmilar probs that corrected problem when reset up ,found a reset jumbled all settings wrongly
may be worth a check
astracat

Woorlord

  • Newbie
  • *
  • Posts: 2
    • Email
Re: Toshiba 19W330DB no DTV/HDMI but Analogue TV & SCART OK?
« Reply #2 on: July 09, 2011,13:34:42 »
Had a look at all Service Menu settings and can;t see anything obvious on setting up digital board.
OK have set the panel type and tuner type as per hardware but no change.

Mulja tv repair portal

Re: Toshiba 19W330DB no DTV/HDMI but Analogue TV & SCART OK?
« Reply #2 on: July 09, 2011,13:34:42 »

jimca007

  • Hero Member
  • *****
  • Posts: 275
  • Is this the one ?
    • Email
Re: Toshiba 19W330DB no DTV/HDMI but Analogue TV & SCART OK?
« Reply #3 on: July 09, 2011,17:38:49 »
personally I detest these vestel combi boards although their all over production like a rash damn near all manufacturers have used or still use vestel stuff anyway I digress ! Try unplugging the eeprom from the board ( obviously with the set unplugged ) then power it up, it'll stay in standby and won't power up. Unplug again and re insert eeprom . On rebooting the eeprom should be re written with system defaults. you may be lucky but found lots of these eeproms going down and replacing and then re writing with a dump's the only cure, however its worth a bash ! good luck!
seldom bested often bamboozled!

Mulja tv repair portal

Re: Toshiba 19W330DB no DTV/HDMI but Analogue TV & SCART OK?
« Reply #3 on: July 09, 2011,17:38:49 »

 

download