Forum > LCD TV forum

Daewoo DLT-37C3FT3 Dead set stuck in standby.

(1/3) > >>

pan:

Hi,
This set is stuck in standby.
Using the R/C to turn the set on only makes the LED flash green but no sound or picture.
The 5v is fine, but 12v & 24v missing.
Any help much appreciated.
Pan   

jimca007:
Don't recognise the set off hand but if you can get a part number for the psu or upload a pic it'd help to give you  some pointers.
On a general note the majority of stuck in standby faults are caused by faulty secondary output capacitors, check them over for swelling or leaking anything that doesnt look perfectly flat on top change.
Hopefully you'll be lucky !

pan:
Hi,
I’ve checked the electrolytic caps (ESR) on the p/s pcb they all check out fine.
Has anyone got the p/s (FEL-3732UL) schematics?
Thanks
Pan

pan:
Hi,

My mistake the P/S is a FEL-3237UA.

Cheers.

Pan

chrissie jones:
had the same set with the same problem before.it was the epprom corrupt.

Navigation

[0] Message Index

[#] Next page