Forum > LCD TV forum

Logik LCXW32HD1-Standby Transformer Problems

<< < (3/8) > >>

Turnip:
Hi S/D,

No-one has yet said what PS is used (Guess it's Profilo with that FSD200 that just pops for fun and our profit)

If so, might well have a 'TR 20'  S/by tranny - few become  O/C - Chris.

PS - if not Profilo - what is it  ?

scooby-doo:
Hi
It is the Amoi PSU. FSD200 was quite badly burnt around a couple of the legs it also took the bridge rectifier on the underside out too.

Should have the second hand board tomorrow so hopefully will be sorted.

Ohm Supplies:
From.memory the tx is made by tdk. Amoi normally manufacture much smaller supplies and as far as I know,none of the transformers on this board are available new. It does the same job as tr20 and to be honest if it was physically further away from the fsd200 it would be ok.

Regards
Andy

scooby-doo:
Hi

Finally took delivery of the board today, fitted the transformer, seems to be a problem

@Andy: What readings should I be getting from the places you mentioned.

I fitted the PSU to the TV and when you turn it on all that it does is all the control lights and the red led start flashing no sequence just  repetitive flashing.

Any help appreciated

scooby-doo:
Hi

Got the flashing lights sorted, I had put U4 in the wrong way round, all I am getting now is a standby light no power etc etc.

Thanks again for any help

Navigation

[0] Message Index

[#] Next page

[*] Previous page