Forum > PLASMA TV forum
LG 42PC1DA repaired psu also FS1 blows help please
Tmg:
Hello Ohm Supplies
To remove the heatsink to get a clearer look at the job of removing the IC I drilled a small hole directly under each screw and used a small screwdriver to undo each screw in turn.
As there does not appear to be any circuit tracks at these points
(but wont know until IC removed)
But as a big soldering iron wont remove all the solder any sense even after resoldering and refluxing I suspect special equipment is needed to remove this IC and it would need a replacement board anyway.
Regards
Tony
Tmg:
--- Quote from: scooby-doo on November 28, 2011,18:07:55 ---I have a board from an LG that looks exactly the same as this but the P/N is EBR61021008...came from a smashed screen LG 42 PQ3000 , if someone can confirm it would work then you can gladly have it FOC to try...as long as you pay postage
I may take up your offer Scooby as its looking like I dont have much more to loose, Otherwise its another scrap set.. :33:
--- End quote ---
scooby-doo:
Sorry mate my mistake...I just pulled the z sus out and checked part numbers and it wasnt the same PN as in my previous post (EBR61021008)....good news is that it is the same part number you have listed..well nearly
On the board itself it says
6870QZH104B
and on a sticker says
6871QZH053B...not 056B
So I am sure this will fit...Offer still stands if you want me to post..the only problem with the board is that I have had to solder wire to the main connector...which I will remove the best I can before I send
Tmg:
--- Quote from: scooby-doo on December 01, 2011,08:53:32 ---Sorry mate my mistake...I just pulled the z sus out and checked part numbers and it wasnt the same PN as in my previous post (EBR61021008)....good news is that it is the same part number you have listed..well nearly
On the board itself it says
6870QZH104B
and on a sticker says
6871QZH053B...not 056B
So I am sure this will fit...Offer still stands if you want me to post..the only problem with the board is that I have had to solder wire to the main connector...which I will remove the best I can before I send
--- End quote ---
email sent to you Scooby-doo
scooby-doo:
No problems matey...glad it fixed the tv
Navigation
[0] Message Index
[*] Previous page
Go to full version