Author Topic: 25X32VSIG Serial flash..a long shot but worth an ask (Read 4028 times)

E Parton · « **on:** November 29, 2011,05:58:13 »

Hi friends ..
A long shot but worth an ask ..
I have a Willem PCB50 and am trying to read a soic 8 pin serial flash
..but having trouble ..getting the Willem to recognise the chip ..
Any knowledgeable Willem programmer users out there know the correct settings for the willem with this device ..
I believe it is also refered to or 'seen' as a 25P32...
rgds
Evan

Mulja tv repair portal · « **on:** November 29, 2011,05:58:13 »

Ohm Supplies · « **Reply #1 on:** November 30, 2011,10:23:39 »

Hello,
I think I have that program on this pc (eprom50???)

Try:
Device
spi-flash (10th down)
winbond
25x32

regards
Andy

E Parton · « **Reply #2 on:** November 30, 2011,13:28:17 »

Thanks Andy ...
I'll give it another go ...
Strangly I can read this chip ..up to a point ..
Some blocks appear protected ...but sees it ok on the EZP2010 ..
but no luck so far on the willem
rgds
Evan

Mulja tv repair portal · « **Reply #2 on:** November 30, 2011,13:28:17 »

Ohm Supplies · « **Reply #3 on:** December 01, 2011,06:21:05 »

I couldnt get it to read on that Wilem either which is part of the reason I don't use it. The manufacturer said it works fine, the fact it doesnt work for me said different.

If you have the EZP2010, use that instead

regards
Andy

Mulja tv repair portal · « **Reply #3 on:** December 01, 2011,06:21:05 »

Mulja tv repair portal

News: