Forum > LCD TV forum

SONY KDL-S40A12U FLASH DUMP-SOLVED

<< < (2/3) > >>

woooow:
So, the tv works now and problem solved, but no hdmi option in menu and when i connect hdmi device in hdmi port picture not comes up. Any advice is welcome. :brinda:

Ohm Supplies:
WOOOOOOOOW

WHat did you do to fix the set? Its not obvious from the info. you've posted

Andy

E Parton:
Like Andy ..I too would like to know how you got the set working..
feedback is important..
..even if suggestions given prove ineffective
rgds
Evan

woooow:
Evan is right. Its not a firmware problem. The problem is in fuse (5v) in T-CON board of the panel. I check every board exept T-CON because the board is behind metal surface. But now seems to be a firmware problem or settings. HDMI option is missing. I connect my satellite receiver in hdmi port and nothing happens. Also check cable( i have 2 ). Any ideas?

E Parton:

--- Quote from: woooow on December 13, 2011,06:55:40 ---Evan is right. Its not a firmware problem. The problem is in fuse (5v) in T-CON board of the panel. I check every board exept T-CON because the board is behind metal surface. But now seems to be a firmware problem or settings. HDMI option is missing. I connect my satellite receiver in hdmi port and nothing happens. Also check cable( i have 2 ). Any ideas?

--- End quote ---

Good to know WooooW...
As I said at the beginning of the thread ..I'm not too familliar with the WAX chassis ..
I do know some sets don't show an HDMI connection until something is actually plugged in to the hdmi ..but if you have used the satellite box on this tv before ..then we can dismiss a 'handshake' problem ...but to prove conclusively it isn't ..try another HDMI connected device ..like a bluray player..
I doubt you need to update firmware ..(assuming you haven't tried inputting firmware already)
More likely ..if you still have a problem you most likely need to enter service mode ...and either enable the hdmi inputs ..or perform a reset ..
There are usually 2 forms of reset available ..one you can do easily ..the other may brick your TV ..so make sure you know which one to perform before trying this ..
I'm sure someone more familliar with the WAX chassis will help you with this ..
rgds
Evan

Navigation

[0] Message Index

[#] Next page

[*] Previous page