Forum > LCD TV forum

XL194-03...Replaced bulgy caps NO 24v from PSU

(1/6) > >>

scooby-doo:
All the caps were bulging, replaced....tv comes out of standby and I can hear static noise through the speakers, the set doesnt shut down, there is just no 24v from any of the pins on the psu I am getting 3v on the same connector block for the signal but thats my lot.

Any ideas people???

Thanks in advance.

E Parton:
Not familiar with the set SD ...but Since elec caps were bulging ...now replaced ...and there is at least some invertor supply voltage ...I would back track from the connector ...and check any 24v supply diodes ...as this most likely (possibly a dual diode heatsink mounted)  ...would have took a clogging ...
best of luck
Evan

E Parton:
OOps misread your post I think ..
the 3v isn't from the invertor supply ?
So s/c supply diodes still look favourite ..
but ...does the set actually come out of standby ...? in fact is there a standby supply at all ?
rgds
Evan

Turnip:
Hi S/D,

Don't think you mentioned known make or model - gives some problems, esp with no piccies - Chris

scooby-doo:
Yes set comes out of standby...it seems to be working all ok apart from the 24v supply.

Will trace backwards later today...I did think earlier that a couple of the box type caps were a bit on the podgey side...but thought I may get away with replacing the electrolytic's for it to fire up....obviously not

But thanks for your help Evan

Oh yes the 3v Supply is on the inverter supply block....

Hi Chris its a Goodmans GTVL32W27HDF

Picture of PSU attached

Navigation

[0] Message Index

[#] Next page