Forum > LCD TV forum

normende nd4260(p.s17pw26-4 v.1)

(1/2) > >>

WILLYAM1:
Hi to all.
first problem;led flickring and all volltages tripping.
change all capi and also ic for stby DL 321(I CHANGED DH 321) TV WAS WORKING fine a several  hours .
in the morning  i operet again to check and delevering to custumer and there is a  problem.
led stby light  by power its off( all volltage ok  no backlight and go to stby again) notice that pin inv /on no volltage and allso pin dim.
check inverter seems ok  not sure if prob is in p.s or main or inverter.
help needed .
willyam1

fix2003:
set would work ok when warm,
but when cold the LED went from red to blue to red again, sometimes the inverter would start for a split second.
check Changing IC830 ,FAN7711 in the PSU fixed the fault.


FAN7711 can cause many odd problems try replacing :thumbup:

WILLYAM1:
thanks VINCE.
its diffrent prob.
i found i short circet in the main board the short is in  i.8v path.
the hdmi ic is shorted.
think that i need ti replace a new main board.
thanks willyam1

WILLYAM1:
hi yo all.
i changed the smt ic SIL9185ACTU but steel no joy.
going back to stby no back light all volltage from p.s ok.
may be a reset needed.any help?.
willyam

WILLYAM1:
Hi to all.
were are the expert for the main board 17mb35-4?.
need help....
i found a lot of this board but its vot the same numbers in the white and the green labels.
its seems that its diffrent software or?.
17mb35-4 10069033 20515440.
help........
willyam1

Navigation

[0] Message Index

[#] Next page