Forum > LCD TV forum

Sharp Aquos LC-32DH500E

<< < (2/2)

sabre504:
HI Kilroys
yes the remote does it all volume and on off and change source ,
not seen a logo but maybe not i not noticed becahse i been looking at remotr as i been turning it on  :57:

Thanks for the manual will update asap .
ProDave thanks for confirming 12v for me
Paul

Kilroys:
Ok
Why I ask about the logo is that in the past
I had one that was only showing the logo and then nothing else.
You should also have some data voltage on the lvds cable
from the video processor.

sabre504:
HI please excuse poor spelling on my previous post was in a hurry .

I will check the cable voltages against the manual and report back later after i have scoured the manual to find what i need and take it from there .
Will try to post some pics if i can get some of decent quality

sabre504:
Update 
I have scoured the SM but cant find anything about the T-Con but hat may be because it is a part of the screen and not seperate .

Have changed the resistor (202) which has dropped the votage from 12 to 4.8 this then leads into a smd capacitor but is not showing voltage on the other side so now have to try and find out what the V and uf are so i can change that .

I know this is not clear to most without any pics but new sd card for camera should be here today so will post some pics

Gazza544:
Hi sabre , I have the very same problem, did you manage to fix it?

Navigation

[0] Message Index

[*] Previous page