Forum > LCD TV forum

Samsung UE40C6005 dead

<< < (2/2)

low.flying.pigs:
All the PSU output voltages need to be correct. The Service Manual shows what to expect where.

http://elektrotanya.com/samsung_bn44-00357a.pdf/download.html

Be careful! Hope this helps,

low.flying.pigs

tumstock:
Everything seems to be correct. I downloaded the service manual and had my friend test the board earlier today.

This leaves me with the main board, is there anything i can try to do? Or is getting a new board my only option?
They seem pretty hard to find.

low.flying.pigs:
You mention you reset the EEPROM, assuming you did that correctly and nothing changed, then you can try a blank replacement EEPROM, and if that does not work, a preprogrammed EEPROM to rule out a failed EEPROM. Maybe you can elablorate on what you did.

If you are absolutely certain the voltages are satisfactory, and if you feel it worthwhile and accept there are no guarantees, then source a replacement of the main board. After finding the PSU to be OK and without a replacement PSU to be certain as far as possible, I'd be looking towards the main board.
 
A local TV engineer may be able to assist, or someone else may have some further advice.

Failing that, unfortunately I don't have a main board available but someone else may if you put a message in the wanted section of this site.

Another option, the main board is available from suppliers in the UK. One such which will dispatch to Sweden by courier is below:

http://www.lcd-plasma-parts.co.uk/index.php?route=product/product&product_id=13616

Good luck. Hope this helps,

low.flying.pigs

tumstock:
http://forum.samygo.tv/viewtopic.php?f=9&t=2844&p=23300#p23150
I used that guide when i tried to reset eeprom, is that incorrect?

I ordered a board from some sketchy site based in Poland for about $30 with shipping included.
Not even sure they will send it out to Sweden tho.. but I selected C.O.D as payment, so it's not that big of a deal if i don't get it.

Navigation

[0] Message Index

[*] Previous page