Forum > LCD TV forum

Info on Lexsor 27"LCD power board component..

<< < (3/5) > >>

downunder:
If it is designated L504, one can only assume it's an inductor. A transformer in theory would be designated T504. Cant tell much from your picture, it's cropped too much to decide which area of the PS it's in. It may possibly be for mains filtering in which case it should have 4 pins. If so, it could be removed and wire links put in it's place for test purposes. How many pins does it have, anyway?

SlyAKs:
There are 5pins on one side and 3 on the other.. On the side with 5 pins only two are soldered to the board.. One reads 230v the other seems to be off the scale of the multimeter or something.. on the side with 3 pins (there are holes on board for 5) only one pin is soldered to the board with the wire coming from copper  wrapped around the ferrite exterior.. Don't know if I have explained this well enough... Can't really say much else about it..

downunder:
Cant get my thinking gear around that, partstore.com list that power supply as being used in Prima and Polaroid brands as well. Not in stock but available as a special order.

SlyAKs:
Right, took a few photos..

http://s910.photobucket.com/albums/ac310/seanl84/


Hope these photos make my last post a little easier to understand...

Cheers, Sean

Turnip:
Hi Sean,

Any chance of a full P/S piccy as it's hard to make it out with just a couple of square inches ?

All the best - Chris.

Navigation

[0] Message Index

[#] Next page

[*] Previous page