Forum > PLASMA TV forum

LG 60PG3000

(1/3) > >>

SlyAKs:
Had a look at one of these today for a friend.. There was one black 2 inch vertical bar running down the screen.. My mate said that the fault was intermittent, so I naturally thought one of the ribbons weren't connected properly or had contaminants on it.. Cleaned them all with alco and reconnected them.. Bar was gone... After a while (30 - 40 mins or so) the bar came back.. Is it looking like buffer boards are needed? Any info would be greatly appreciated.. steep learning curve these tv's! Lol

t1412:
hi, can you see any smd resistors on the bottom buffer boards, if so these might be dry jointed

regards
shaun

SlyAKs:
Cheers for the reply Shaun.. was just reading up on the fault and found out it could possibly be a dead driver..What's are the odds? You say bottom buffer boards, all I could see where the two to the left of the y-sus.. do you mean on these boards?  :sign0144:

Cheers, Sean

t1412:
hi again,just thinking out loud i've seen plasma tv with these board some go the length of the tv must be older ones, have you got service a manual if not,i've just sent you one, if you get a chance can you take a picture of the tv thanks.

s
shaun     

SlyAKs:
The tv....

http://m910.photobucket.com/albumview/albums/seanl84/LG%2060PG3000/20121123_143815-1.jpg.html?o=0

Sorry for poor quality as it was sent to me via txt.. My mate said the bar will change from solid black to slightly fuzzy and sometimes there will be image on it but the line is still obvious..

Cheers again, Sean...

Navigation

[0] Message Index

[#] Next page

Go to full version