Forum > LCD TV forum

Samsung LE40M86BD Not Caps/Flash?

(1/4) > >>

CraXyOW3:
Hi, first time posting here so bare with me!

Yes, i have first searched the forums and checked and double checked everything.
Have found most of my answers here just by reading! Now i have to post.

So i got this Samsung LE40M86BD, it was repaired once by me with the typical "bad caps" procedure about 1½ year ago. Now it did the same again, clicking and won't turn on.

I checked the caps but there are no apparent or otherwise visible bulges or other defects, anyway, swapped them just in case. Still clicking.

Read up on these forums and saw the eeprom error, i added a tactile switch for lazy shorts, feels better for me than just 2 bare wires.
Even this procedure didn't work BUT, when reseting eeprom the tv sets it selves in standby instead of just turning on, so my tought is, mainboard should be working ok?

Anyway, one thing that is noticable is the TM801S Transformer is "whizzing", not the typical high pitch noise, also this "whizzing" is increased as the relay kicks in and goes away the moment the relay goes off.

What i can tell if i still can read schematics the DM851 should read 12/13volts and DM857 should give off 5 volts?
I have typed down the value i get on respective components on the following image.
Also in yellow the changed caps (again.)

PSU number bn44-00165A.



EDIT:
Reference thread before this question was asked -> Samsung LE40R88BD Clicking Relay

marky mark:
Trying to blank the eeprom doesn't always work, you might of just screwed it up, so well done for being lazy. Have you looked for dry joints on the transformer?

CraXyOW3:
No dry joints,was one of the first thing i was looking for but one can never be sure as they can have micro fractures.
I did put fresh solder on it just in case, but no dice :/

jordan:
ICS-802 (TL-431) ???

CraXyOW3:
Found only 2 matching components to TL-431, Named UM851 & UB851 with designation KIA431A.
In the schematics it's labeled KA431 and UM851 is in association with the TM801S with the noise so i am going to measure the values of those two Shunt Regulators and thanks for such a precise answer!

Navigation

[0] Message Index

[#] Next page