Forum > PLASMA TV forum

bush pdp42tv006 dead (take fuse of ysus board sound but no picture)

<< < (2/3) > >>

ernie:
the y sus has (6871qyho45c)part no 6870qye011b.....ydrvtp has(6871qdh094a)part no 6870qde114b.....ydrvbt has(6871qdho96a)part no 6870qfe114b......hope these numbers mean something if not i will try to take a picture thanks for looking into this

ernie:
replaced y sus,z sus,and control board now the tv is perfect,three board repair kit was £85 so cant complain

Ohm Supplies:
We sell the PDP42V7 kit.

http://www.ohmsupplies.co.uk/epages/ohmsupplies_co_uk.sf/en_GB/?ObjectPath=/Shops/ohmsupplies.co.uk/Products/KIT01

All boards should be set up after fitting, VS, VA voltages on the Main Power Board and adjustments should be made on the new YSUS board too.

Regards
Michelle

ernie:
what happens if you dont set these boards up after fitting?,as i have just changed mine and it has been ok for three days now,also where would i find any information on setting them up.pity i didnt know about your shop before as i tried all over to get these boards before a shop round our way got them for me,could have saved me £18         ernie

Ohm Supplies:
Ernie.

These boards are quite common to go in sets using the V7 PDP and they’re used in many different makes. If you have a picture then they’re set correctly, occasionally you have problems.

As for set up information there is some available, Not sure if posting it here is a breach of copyright but as with most faults there is service info. its just a case of getting it.

If you want it I could email it I suppose.

Regards
Andy

Navigation

[0] Message Index

[#] Next page

[*] Previous page