Forum > LCD TV forum
Repair faults section
Bambooz:
--- Quote from: meerkatmtd on September 15, 2011,11:00:48 ---Hi everyone I have read a few subject threads about flashing standby lights and have replaced the caps and hey presto - Standby light still flashing what else do i try? any info would be appreciated.
chris
--- End quote ---
the FSP212-3F01 psu is notorious for blowing other parts when the caps go pop.
see attachment (which is a general "fix-all-possible-problems-at-once" kinda thing. check the parts first if possible)
If you can't get it fixed, i've got one collecting dust somewhere (out of a noname 32" tv with cracked panel)
edit: :oops: .. didn't notice how old that post was
meerkatmtd:
that's alright the tv is still not working, think will source a replacement power board, have seen one online for £55 so might get it fixed, in the mean time i got my hands on a new cheap lcd. thanks for you post at least interesting that could almost be any part on the board that could be a fault?
sabre504:
HI if you still have the psu
replace all the caps on the secondary side not just the 2 1500uf
Change Q7 ( bc848 ) and ZD4 15 volt zener diode as a start point usually fixes
denniswu163:
the FSP212-3F01 psu is notorious for blowing other parts when the caps go pop.
COWBOY:
HI GUYS,I HAVE A 42INCHES LCD TV MODEL NO 42LC2RR AFB
FAULT:no start up.stand by led flashes from red to green.
any help...............
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version