Forum > PLASMA TV forum
Samsung PS-42Q96HD Power fault
downunder:
Happens to the best of us, Turnip, c'est la vie. Doesn't sound like caps but who's to know. Have a note for no go, relay clicking: replace CX817, CX823, CX824, CX826, CX834 and CX835 in PSU secondary as well as
CB613, CB803 and CB814 in the primary. Might also pay to revisit CX801/2 for dry joints.
Turnip:
Hi Bruce,
Well said, and love that French from an Aussie.
Went for a repair pack that didn't involve a fuse, as didn't have a duff one.
Pack has pile of caps, as you suggested and will natch check those original bits for dries.
If successful, will try improve language.
Thought you chaps got sent there after sheep stealing - Too much Dickens, perhaps.
downunder:
Hi Turnip,
We're a multi-talented, multilingual, multicultural lot. A tad light-fingered too....taxes, cricket trophies, and a few wooly sheep as well. Willy Shakespeare was the go in my youth, with a smidgen of Dickens.
Bon chance with your repair kit. Be interested to see where this goes. This model was a bit of a bad egg.
Turnip:
Hi Bruce,
Admit I've always hated Plasma, as they used to have a toughened glass screen, so a brick or RCU was usually shugged off, so they became quite old before recycling sites met them, and were always analogue, horribly heavy and with sparklies where one twiddled pots to best effect.
Note modern sets have dispensed with the front screen to try be as nifty as LED backlit sets. Upshot is a load of panels on the Flea that one can't use as we don't have a usable screen.
Thought this Sammy was nifty, as was DVB and had the toughened screen. Made a useful pound from the double fet PS dries, but after some years are beginning to haunt me.
To the point - replaced all those supplied caps (which included the one I mentioned) also re-visted those two hot fets plus all the devices on the secondary heat sink for possible dries.
Reading 'King Lear' and 'Bleak Workshop' - again, as things can only get better - Chris.
PS - will note on Quuq - success, or even failure.
Turnip:
Hi Bruce,
After certain OK days, dries seem the main biz.
Not sure whether those two hot Fets were again the trouble, or possible dries on secondary devices, as re-soldered them all.
Thought mention - Replacement caps - cool, possibly innocent - apart from that 1000/25 def bulgy and duff, but not sure whether was the main problem - guess not - Chris.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version