Forum > LCD TV forum

MEGMEET MLT169B Power supply

(1/2) > >>

old tvman:
Can anyone help with a circuit diagram for this power supply or can tell me the value of resisters  R12 and R13
TIA Davy.

Turnip:
Hi Davy,

Don't think have yet met one. Nice to know set make/model, and perhaps a piccy as could be useful - Chris.

OldLes:
I think I have a PSU type MLT198 somewhere. I had this on the bench LAST July. Out of a Goodmans (also Bush and some Grundigs) but with no info available, I think I pulled the PSU (which looked OK) and scrapped the big parts.
Have a look back at my post, I did add a couple of photos.
Les.

jordan:
R-12=330KR
R-13=330KR

fix2003:
MLT169B PSU repair
 from a Tevion 32" but it was worth it. PSU Blown up.

Repaired now! Replaced Q11 used FQPF8N80C and re made vaporised print. Replaced r12/13 are 47r had to use wire ended due to burnt print changed 2n2 1k connected to these resistors looked charred but read ok. R68 was ok it is 68k Replaced D14 HER207 Z4 1N4739A All electrolytics (that I could see)

Plugged in and set worked but after I had tuned in I felt the heatsinks! HS2 (not the one with q11 on) was frying and producing steam from a wet finger.

Removed heatsink assy and found 3 more electrolytics lay flat all high ESR and low cap but the fault was D5 PFC diode dead short FSU05B60 replaced from scrap board.


may help

Navigation

[0] Message Index

[#] Next page