Forum > LCD TV forum

baird x32dtv

(1/1)

t1412:
hi chaps had this baird x32dtv psm210-417-r, psu dead no voltages fuse was ok, heated board up tv came on, so replaced caps secondary side. but still the same fault, tv only comes on when i heat the board any got diagram going thanks for your time

regards
shaun         

Turnip:
Hi Shaun,

Usual problem is where the 5v S/by supply chip pops - Ohms does a kit. Wonder if you have a pre-pop problem where 5v is only present with heat - No shematic - Good luck - Chris.

t1412:
thanks for the reply chris, you may be right, if i press the power button nothing as soon as put heat around the chip area spring to life thanks

shaun     

t1412:
hi chaps would it be ok to use a psa218-417-r to replace psm210-417-r thanks

shaun   

Navigation

[0] Message Index