Forum > LCD TV forum

Sony KDL-37V4000 - Bright picture.

<< < (2/2)

Turnip:
Hi folks,

Thanks for help - Much appreciated, Esp the Kapton tape.

First time I had the problem was with a 'Sammy' so bought chip for 99p inc post, as a Quuq chum offered to replace it for a drink.

He did a really neat job but when re-fitted, LH side of the picture was missing, but no solarisation at all on the good bit.

He mentioned that £0.99 chips are 60% crap, which is a pain if you've just changed one for a drink.

Also suggested a supplier of known good chips for £1.50 inc post - Guess best option - Chris.

zomikula:
Ordered 10 off ebay from china not had a bad one yet.
gone through 5.

you plenty of flux
and read up about drag soldering,
and use solder braid to clean up at the end.

Yeh and watch out for those that have a solder pad underneath them
best to nudge them when heating up

I use hotair station at 370 C and air flow at lowest setting,
normally about 20 -45secs and the chip is off.
But always nudge it slightly..

Defo use the tape.
Once I was lazy and didnt use and ended up pushing the chip abit too much
and displaced a few components..

Turnip:
Hi Zom and well said,

Not sure about 'drag soldering' but will def use the tape now I've bought some.

What's plenty of flux - Maybe used before de-soldering, and if so, why ?

Glad your 99p chips did the job - Will stick to 1.50 a pop 'till quite sure, as margin is still pretty good.

Have a hot air station, previously only used to shrink sleeving - Thanks a lot - Chris.

zomikula:
this explains it well

https://www.youtube.com/watch?v=wUyetZ5RtPs

With out flux its hard to get the solder to stick properly.

Navigation

[0] Message Index

[*] Previous page