Forum > LCD TV forum
samsung le40m86bd
t1412:
hi fella's happy xmas to all, samsung le40m86bd kept swiching off and on replace the usual caps changed epprom went into service mode did a reset, tv comes on ok runs ok for 10 to 20 minutes then the picture freeze's then clicks off and back on again now if connect a freeview box through scart lead tv runs ok would you say the tuner is causing the trouble thanks for your time
shaun
cheeky2:
I had a le46m87bd (very similar board) doing something similar it just kept intermittently turning itself off and on! Reset the eeprom a few times and changed a couple of the solid state 1000uf 6.3V(might be slightly higher voltage) under the soldered screen. Resolved the issue after service reset a few times! The caps were a little high esr 0.5 ohms but not gone. These capacitors on this board get really hot which is quite surprising which i guess why they go quite often.
Good luck :)
t1412:
hi cheeky the metal casing is this dtv part on the main board your refering to and the smd caps thanks for the info much apprciated
shaun :sign0098:
cheeky2:
They are 10V 1000uf see attached picture i have removed them before from a faulty same board that have also a couple of them to the left of the screen. You will need a decent soldering iron to remove them as the pads on them are quite large ( in fact i lifted one of the pads when taking them out).
Good luck
t1412:
hi thanks for the info again, the smd you can snap them off and use electrolytics caps, if you have the room, more reliable. thanks
shaun
Navigation
[0] Message Index
[#] Next page
Go to full version