Mulja tv repair portal
Equipment Repairs => LCD TV forum => Topic started by: zoz on January 21, 2012,15:21:38
-
Hi everyone, :sign0144:
just joined your site and hope your can help a newbie out here....
I have a Hitachi L42VC04U H that purchased at a prety cheap price as it only came on for 20 mins then the display would go multi coloured.
problem seemed to be dodgy lcd panel tape joints which I seemed to fix.
Set work ok for a while then display became pixelated.
Tried to turn back on the following day and would not come out of stand by.
Fault as follows
Turn power on
Stand by comes on (red led) then off
then blue led flashes very fast then off
and then back to steady red
Any help would be much appriecated
Thanks in advance Zoz
:08:
-
Unfortunately stuck in standby is prob the most common fault you get on these flat screen tv's it can have many causes but due to the fact you have picture distortion prior to the fault it would have me thinking the power supply's faulty. try the usual , make sure you've not disturbed any cables going to/from the psu during your previous repair,inspect the soldered connections on the rear of the psu for dry joints/burnt tracks/blow marks and take a good look at all the capacitors on the psu for bulging/leaking. if all that seems ok you need to get a diagram for the PSU being a hitachi there's a fairly good chance it'll be a vestel psu get the number off it and maybe one of the guys will have a diagram to let you check the voltages.... and on it goes ....!
-
Thanks for quick reply. :c017:
The power board is a Vestel 17PW26-4 v.1
after a late night of changing caps on this board the problem remains I did notice that I do have the opto sound alight on the main board.
What next...?
Drawings anyone or pinout voltages......... :thumbup:
-
here you go
-
Thanks Jimca007
Im just checking my board and it doesnt seem to match....??!!
I have a plug connection marked PL816 which is a 28 way connector to the main board, I can't find this on the drawings...different version maybe.
-
UPDATE
just chucked it all back together..again
Powered up ok but screen had green and some red pixs all over. (random pattern)
No sound though
turned off again and now reverted back to same problem red standby, then the flashing blue back to steady red.
Arggg
-
hi,
think there's a problem on the power board and main board as well.
-
Hello,
Can you advise me , I have the hitachi l42vc04u H
It changes from red to blue light momentarily, but returns back to stand by.
If I hear the board with a hair dryer it will go in to full power and stay on.
Any advice please?
Thank
You alex