Mulja tv repair portal
Equipment Repairs => CRT TV forum => Topic started by: Fergusson on February 17, 2012,07:30:30
-
My tv repairer has fixed some faults that i wanted done but in the process now has another problem where the sound and brightness goes from 0 to full with nothing inbetween .The set has had its battary replaced as part of the work .It is Ferguson Tx 51A3 .It is puzzeling him so i thought i would ask for help.
-
hi
you will have to go into service mode to set up
cannot remember the red,green,blue,or yellow
buttons to press in what order sorry try and
find service manual
dave
-
Hi,
Being a few days older than Sparky, I seem to recall the backup Nicad drooled down the vertical control panel LHS and corroded most everything beneath - perhaps a modern LCD could be an easier option and would save finding screen clips - Chris
-
Hi, Can't remember the colours but to enter menu . Coloured buttons from left to right 1>2>4>3. Hope this makes sense, Doug
-
No coloured buttons, 51A3 is pre Fastext.
To OP do the manual controls on the set work? it sounds like you have a memory problem, to store the settings you need to press the normalise store on the front of the set.
-
Hi,
Lots of info on the older TX chassis here http://www.highlandelectrix.fsnet.co.uk/tvs/FERG_TX.TV.html#TX10
TX100 is also there
Keith
-
I need your help.
-
I need your help.
WHY ?
-
Hi Ferguson: Look closer at the message, it's SPAM to advertise what they sell.
Andy
-
shall we exterminate him, hes getting a pain in the ****
-
Hi Tony: Sounds like an excellent idea to me.
Andy