Mulja tv repair portal
Equipment Repairs => PLASMA TV forum => Topic started by: docront on December 16, 2011,03:36:47
-
Hello,
I connected an Apple TV (ATV2) to this TV using the DVI port (HDMI to DVI cable). The issue is I keep on getting the No sync.signal message and after a minute or so the TV goes in to standby mode.
This DVI port is fully functional as I tested the connection with other devices. I read on some forums that it might be a firmware issue and I was wondering if someone can point me in the right direction. This TV was purchased in Europe and I am now in New Zealand where Hitachi TV's are not serviced.
Many thanks,
Ron