Mulja tv repair portal
Equipment Repairs => CRT TV forum => Topic started by: tammu on May 26, 2010,21:48:22
-
Pin cushion is not getting corrected.Remains cut in picture from both the sides.replacing pf in horizontal section no help.replaced NJM2903 pin amp ic also no help.what could be the problem?
thanks
-
Hi,
Model number doesn't help, what's the chassis ? - Chris.
-
Hi Tammu,
Check & replace components C6857,L6815,R6932,L6803,Q6801. These r the likely components which usually fail in such cases. If this do not help open service menu & check EW drive. Coils may become short, if so rewind them. Good luck!
:happy:
-
Hi - So what's the chassis, for other Quuq folks who might have the problem ? - Chris.
-
Obviously chassis no is CX-1. Turnip!