Mulja tv repair portal
Equipment Repairs => CRT TV forum => Topic started by: t1412 on June 13, 2011,11:08:07
-
ok guys got this old beko it's a nr35228pd repairiing it for an old lady up the road. at switch on dead took the back off found main fuse blown put another1 same again tested output transistor ok . any other ideas got a feeling it could be the lopty cheers
shaun :sign0085:
-
hi
check psu for shorts, if none change positor
good luck
daz
-
cheers daz you would happen to have a schematic knocking about cheers
shaun :c017:
-
sorry shaun dont have one for this set, but some other quuqer might
-
Hi T1412,
Had lots of tubed Beko in where spurious mains fuse blowing was a decent earner - got rid of most my positors apart from those odd Philips ones that were not series in operation - typical Philips - they just have to do it differently.
Have a schematic - attached - all the best - Chris
-
i.ve change the posistor it stop blowing fuses but still dead. chris really gratefull for the schematic
shaun :c017: