Mulja tv repair portal
Equipment Repairs => PLASMA TV forum => Topic started by: P.R.Gore on August 16, 2017,07:41:28
-
Hi,
LG plasma tv ; model number 42PN4500 is showing picture with enormous number of black spots or say patches. All voltages that mentioned on panel steaker seem normal.(Vsus & Vad ). Please observe attached photos & suggest solution.
Regards
P R Gore
-
Looks like a faulty Z-Sus to me.
You could disconnect the flexi from the main board to the control board (under the PSU). At probably around 4 o'clock position on the big chip on the control, you should find the auto gen test points - could be marked R51/R52. Short these out and check the test patterns. If OK, main board is faulty.
If not, probably Z-Sus. Bruce
-
Bruce,
As per your suggestion I connected jumper, the same fault appears in test pattern also. So fault should be in Zsus board. Can Zsus be repaired at component level ? Any repair hint?
Thank you very much for this repair suggestion! Waiting for your further reply.
P R Gore.
-
No specifics, just to check FETs and Diodes for shorts and dry joints. - Bruce
-
Ok. I will check & update.
Thanks.
-
Doesn't quite look Z-sus to me. Hard to tell from camera shots but it looks to have plenty of brightness to it.
-
I throughly checked Zsus board but could not find any def
ective igbt or fet,I also I tried by replacment of electrolytic
Capacitors. But problem remains same.
-
Might be time to move to the Y-SUS. Do Vs and Va match the values printed on the panel label?
On the Y-SUS check D515 and fuse FS501, and resolder the adjacent transformer. Bruce
-
Thanks Bruce,
This set is still pending at my workshop, I will check as per your suggestion & revert.
P R Gore