Mulja tv repair portal
Equipment Repairs => LCD TV forum => Topic started by: t1412 on October 08, 2018,17:29:51
-
hi chaps got a panasonic tx-l32s10ba the fault, is you switch it on backlight flashes up for a second, you can see the image then tv switches off with red standby light flashing slowly, my thoughts bad tube thanks for your time
shaun
-
Hi Shaun,
I take it that this is a CCFL backlit TV? Sounds like it's giving a Code 1 error message, 3 seconds between each blink, which is an invertor SOS. So it could be lamp short circuit protection, lamp open protection or arc protection, in short, a buggered CCFL, or it could be a fault on the psu, like dry joints or mismatched resistance on the inv. drive transformers. Something to be getting on with, anyway. Can upload service manual should you need it.
Bruce
-
hi bruse thanks for the info i've solder the 2 transformers if you could load a manual that would be great thanks
shaun
-
OK, so I've uploaded it as TH-L32S10A, which is the Oz version of the TV. Bruce