Mulja tv repair portal
Equipment Repairs => LCD TV forum => Topic started by: seagate2020 on September 10, 2020,21:58:02
-
Hello,
I have a Bush TV DLED32287HDCNTDFVP with the Picture Upside down.
I have entered the engineering menu using , menu 4725.
However there is nothing in the menu to flip the screen. I have also factory reset.
Anyone got any idea.
Thanks.
-
hiya what happened before this problem as it looks like its firmware was updated with wrong version ?
need more info before can give a better help
regards
astracat
-
Hello,
Thank you for replying to my post.
I bought this TV thinking it was a matter of just entering engineer mode, but i got that wrong.
The seller did not let me know how or why the picture was upside down. I am sorry I do not have any more information.
Any help would be appreciated.
Regards Dave.
-
Hello,
Here is a picture of the firmware
Thanks
-
hi ,you need to check screen number with panel number in firmware if wrong change it to correct one (screen number written on sticker on back, remove rear case to see it) if its the same then you have wrong firmware installed
regards
astracat
-
Hello astracat,
Yes you are correct the screen panel does not match the firmware please see photographs. i personally think the main board has been replaced.
I have never done a firmware on a tv but have done on other devices.Also I do not know where to source the firmware code and how to load it.Any help would be appreciated.
Thanks Dave
-
main AV
-
hi
updates are from the manufacture its made by vestel send them an email with model and serial number they are quite fair with suppliying firmware if its still available ,unzip it onto a usb stick put in tv before plug power up and it should do its job ok
if not available some one would have to take it from another tv .sorry i do not have it or you can replace main board from another supplier
also some models have a second service page via same number while in it service mode (ie menu 4725) but do not know if that applies to your tv
regards
astracat
-
Hello,
Thanks for the reply. Managed to source, to what I think is the correct board on eBay. MAIN AV BOARD 17MB110P 10105400 23455886.
The 23455886 seems to correlate to the correct panel. I'll let you know the results when the board is fitted. I have also found this link if it is of any use. Provides the firmware by email.
https://www.ebay.co.uk/itm/17MB82-17MB95-17MB97-RECOVERY-SOFTWARE-FIRMWARE-TOSHIBA-BUSH-POLAROID-PANASONIC/164170704055?hash=item26395624b7:g:T7wAAOSwOhda46ga
Regards Dave
-
I guess he has access to the Vestal service portal and could probably get any off us, any vestal file we needed