Mulja tv repair portal
Equipment Repairs => CRT TV forum => Topic started by: theba on September 18, 2008,02:31:02
-
I have got Philips CRT tube, wide screen TV. Model: 32PW8806/79R. TV operates normal when ON, but once you turn off TV, and then try to turn back ON it takes between 1 to couple of minutes to start back on. 3rd LED on the left when you look TV from the front, is usually green, when is on. When is off, LED is red. But when i try to turn ON TV, that LED flashes (red) until TV is back on. At the back can hear like clicking noise. I have tried to replace the batteries on remote control to see if any changes gonna happen. But nothing. Any suggestions. :ciao:
-
Hi,
This fault is usually caused by the relays themselves being intermittant- you would have to prove by substitution (chassis is MG2.1EAA)
-
thanx for advice, might try that. where i can d/l circuit diagram for MG2.1EAA chassis?
-
Hi Ive just uploaded the manual to this site ( I've never done it before -let me know if it works!)
Good luck
-
yep it was a relay in power supply. what has happened, it was making a contact, but it had some corrosion on the contact which cause that problem. has also some dry joints. replaced a relay and it works fine :)