Mulja tv repair portal

Equipment Repairs => LCD TV forum => Topic started by: phillotus on October 08, 2008,15:59:29

Title: SHARP LC 32SD1E
Post by: phillotus on October 08, 2008,15:59:29

hi everyone i currently have 2 of the above sets infor repair with the same fault ,which is colour very distorted flickering back ground either blue or green not as bad when contrast turned right down please see attached photos

Title: Re: SHARP LC 32SD1E
Post by: mulja on October 10, 2008,05:33:37

Check LVDS cable from main board to screen
pull it out clean and put it back.

Title: Re: SHARP LC 32SD1E
Post by: phillotus on October 17, 2008,02:33:59

set now repaired it is the eeb setting in service mode need to enter service mode then clear both eeb setting 

Title: Re: SHARP LC 32SD1E
Post by: mulja on October 17, 2008,04:53:39

How enter service mode? :wink1:

Title: Re: SHARP LC 32SD1E
Post by: phillotus on October 20, 2008,15:06:29

to enter service mode
1 switch to standby then unplug from mains
2 press and hold V- and input buttons on front panel while plugging in
3 letter K should be displayed
4 press and hold V- and P- buttons to enter service mode
5 unplug to exit service mode
 :clap: