Mulja tv repair portal
Equipment Repairs => LCD TV forum => Topic started by: buffy on November 21, 2008,18:22:35
-
Why does no one ever reply?? is it coz i is a girl?? :rofl:
C
-
Hello Miss Buffy
I doubt that being a girl would be the reason for people not to reply. More than likely no one knows.
As far as your Toshiba goes I dont know, but you have replaced everything & it should work simple as that. I guessing at what you are thinking? about panel brand etc. I'd been complaining to supplier for a new one with same brand.
Is it under warranty, as I find it impossible justify cost of repair of these small LCDs with major rebuilds.
Best of luck
-
That got a reply :yahoo: the Tosh is doing my head in, the panel is OK, its something on the settings i think? Have you ever wondered how far you could chuck a 20" paperweight :wink1: ? The other one i have with AUO panel is a superb picture, BUT i cant access any menus, coz there is no OSD/remote/tuning functions etc.... so its like a an old Fergie 30 years ago :rofl: get up to turn it on/off and turn sound down.... The thing is fine by using the SKY remote, to change on the box.... etc.....
Anybody want a CMO Panel for a 100% WORKING 17MB08P (WL) board!!! I got a Cello from the Tip that was as dead as a Dodo, and even thats miles better :dubbio: after replacing capacitors!!!! and splitting the screen in two to get the s*** out!!! oh joy!!!
Carol :blum:
-
You have to be careful when changing LCD panel on Toshiba sets because some of them operate with different screen supply voltages - so you really need to change like for like!
You can normally tell on Toshiba sets which LCD panel is fitted by looking at the 'letter' after the serial number i.e. A= AU, C = ChiMei(CMO) etc.
Hope this might help
-
I have done - it had a CMO screen LO1 replaced with same, i was hoping it had the AUO screen, coz i have one of those!!! anyway - i am getting the remote 2morrow, so i hope a factory reset might do it...
Can any one post the settings on here in service mode???? both sets Adjust and Options? :thumbup: PLEASE!!!!!!! I suspect something is set wrong?? either that or its the inverter input voltages???? :wallbash: The thing is i want to sell this one on locally = to raise some cash to reapir the Sony Bravia with cracked screen!!!! (155 quid D'lec) which is MUCH nicer!!!
Carol
-
i am sure that people would go out of their way to help especially "cos u is a girl"
i will post you manual, "cos i is a guy" btw, what is the model?
-
Hi Tony,
No worries i have the manual(s), guy :loool: its a 20WLT56B, i cannot seem to get to the screen that sets up the TV :wallbash: It tries to hunt for digital sigsm but there aint none here yet!! then whatever i press just starts all over again..... I need to get in SET UP - cant find a way???? Or Do a factory reset from service mode, cant find that either OR get the settings from a worker.... (watch this space) i suspect something is set wrong....... Coz the other Tossershiba i have is a lovely piccy, but cant get into anything :wallbash: coz the menoria chip is buggered - i think!!!! anyways working on that one!!! great fun :wacko: